Getting Started Guide to ET-200 (WeTrack2) GPS Tracker
1. How to turn on the WeTrack2 (ET-200) GPS Tracker
- Simcard activation like this
- Open the cover of the GPS tracker sim card cover
- Enter the sim card
- Turn on the power of the GPS tracker
- Close the GPS tracker sim card cover and connect the device with external power to charge the internal battery
- The charger cable is equipped with a 2A fuse protection to prevent short circuit
2. Installing the WeTrack2 (ET-200) GPS Tracker device
- Install the built-in water protection on the ET-200 GPS tracker as shown below on the right
- Choose the best place to install the WeTrack2 GPS tracker
- Standard voltage is 9 - 90 volts, red wire (+), black wire (-), 12/24 volt relay, orange wire to ACC
- If necessary, use a cable tie to secure it
- The final result is like the example of my motorbike below
Post a Comment