How to Setting and Use The Concox WeTrack2 (ET200) GPS Tracker

 How to Setting and Use The Concox WeTrack2 (ET200) GPS Tracker

The Concox Wetrack2 GPS tracker is similar to GT06N. The difference is the smaller physical form and the absence of voice monitoring features. 

The Major SMS command list for setting is the same as for setting the GT06N GPS Tracker. 

List of Wetrack2 SMS Commands:

1. Setting the GSM provider APN

• APN,[apnname],[user],[pwd]#
  APN,telkomsel,wap,wap123#

2. Server settings that will be used

• Server www.tracksolid.com
  SERVER,0,47.89.58.215,21100,0#
• Server ruhavik.gps-trace.com
  SERVER,0,36373.flespi.gw,21546,0#

3. Setting the interval for sending location data via GPRS to the server

• Send position data via the GPRS network every 60 seconds
  TIMER,60#

4. Activate GPRS mode

• To activate GPRS mode
  GPRSON,1#
• To deactivate GPRS mode
  GPRSON,0#
• To read the parameters that have been set
  GPRSSET#

5. Check the location using SMS

• To get information in the form of GPS coordinates
  WHERE#
• To get information in the form of a Google Maps link
  URL#

6. Add SOS number (special number)

• The SOS number is the number used for the alarm report from the GPS tracker. There is 3 SOS number that can be registered. GPS tracker will send an alarm SMS if something happens (for example, the battery is removed)
• To add SOS number:
  SOS,A,1st number, 2nd number, 3rd number#
  SOS,A,08123456789#
• To delete 3rd SOS number:
  SOS,D,3#

7. Adding the center number

• The Center number is the number used to command the relay (turn off the engine). This number must also be registered as an SOS number.
  CENTER,A,08123456789#
• To delete center number:
  SOS,D#

8. Command to shut down and start the engine

• Only through the center number can turn off and turn on the engine.
• Engine shutdown command:
  RELAY,1#
• Engine start command:
  RELAY,0#

9. Viewing the parameters on the GT06N

• Check parameter settings:
  PARAM#
• Reply:
  IMEI: 353419032348877;
  - Device IMEI number;
  GPRS Interval: 10,10;
  - GPS data transmission interval via GPRS;
  SENDS: 5;
  - GPS time works when ACC is off;
  SOS: 15942703401;
  - SOS number for receiving alarms, a maximum of 3;
  Center Number: 15942703401;
  - Only 1 center number for the command to turn off and start the engine;
  Sensoralm: 10,3,1,180;
  - Detects 3 vibrations in 10 seconds; alarm delay time is 180 seconds;
  Defense time: 10;
  - After 10 minutes ACC power off will enter alarm standby mode;
  TimeZone: E,8,0;
  - Time zone setting; The default is E8.

10. Viewing battery status, GPRS, GSM, GPS

• Check Status:
  STATUS#
• Reply:
  Battery: 3.99V, NORMAL;
  - 3.99 V battery voltage, normal functioning
  GPRS: Link Up;
  - GPRS is well connected and can send location data to the server
  GSM Signal Level: Strong;
  - Strong GSM signal
  GPS: Successful positioning;
  - The device gets a good GPS signal
  SVS Used in fix: 9(11);
  - Number of connected GPS satellites
  GPS Signal Level: 34,22,35,34,37,30,23,33,38;
  - The GPS signal level is strong
  ACC: OFF;
  - Car engine condition is off (ACC off)
  Defense: OFF;
  - Under normal conditions, not an alarm standby mode

11. Restore factory settings

• FACTORY#
  Reset all parameter settings to factory default

12. Reboot the device

• RESET#
  If there is something such as the device being unable to send the location, do a reset

13. Over speed alarm

• SPEED,3,120#
  If the car moves more than 120 km per hour within 3 minutes, the device will send an over speed alarm