How to Setting Concox GT06N GPS Tracker
After the sim card is installed, turn on the GPS tracker by sliding the ON / OFF switch next to the sim card slot. Make sure the green GSM Led indication lights up continuously (has entered the GSM network).
Use your cell phone to send an SMS setting command and send it to the GSM number that has been installed into the GPS tracker. Perform the following command sequence, wait until the SMS is sent. You will get an SMS reply then proceed to the next command:
1. Setting the GSM provider APN
- APN,[apnname],[user],[pwd]#
APN,telkomsel,wap,wap123#
2. Server settings that will be used
- Server www.tracksolid.com
SERVER,0,47.89.58.215,21100,0# - Server ruhavik.gps-trace.com
SERVER,0,36373.flespi.gw,21546,0#
3. Setting the interval for sending location data via GPRS to the server
- Send position data via the GPRS network every 60 seconds
TIMER,60#
4. Activate GPRS mode
- To activate GPRS mode
GPRSON,1# - To deactivate GPRS mode
GPRSON,0# - To read the parameters that have been set
GPRSSET#
5. Check the location using SMS
- To get information in the form of GPS coordinates
WHERE# - To get information in the form of a Google Maps link
URL#
6. Add SOS number (special number)
- The SOS number is the number used for the alarm report from the GPS tracker. There is 3 SOS number that can be registered. GPS tracker will send an alarm SMS if something happens (for example, the battery is removed)
- To add SOS number:
SOS,A,1st number, 2nd number, 3rd number#
SOS,A,08123456789# - To delete 3rd SOS number:
SOS,D,3#
7. Adding the center number
- The Center number is the number used to command the relay (turn off the engine). This number must also be registered as an SOS number.
CENTER,A,08123456789# - To delete center number:
SOS,D#
Post a Comment